Hi all,
Been having some issues with my f350 07 6.0. As I was driving home the other day my truck started running rough losing power and eventually stalling. It seemed as if I had run out of gas. Let it sit for a few minutes and it fired right back up and ran fine the whole way home. this last weekend i took the truck on a trip about 300 miles for the first 200 the truck ran fine on my last 100 mile stretch it started acting funny again losing power and stalling. Finally had a light come on and scanned it and it read P0460 and now my gas gauge is stuck on full at all times. let it sit and it started right back up and ran fine for another 15 miles and would stall again this happened multiple times tell i finally had it towed. The shop tested the fuel pump pressure and dropped the tank to check the sending unit and said everything looked good and when they took it for a test drive it drove perfect. Went to pick it up and it stalled again once i got it home but fired right back up and ran fine the gas gauge is still stuck on full and the shop cant seem to figure it out. Any advice before i keep dumping money at what seems to be a ghost problem thanks
Dylan

 

-Mike

 

In the books it says sensor circuit open circuit , short, cluster, tank unit,open return. Start at the HFCM and work back to the tank , could be wire nic in the wire or shorting out , may need someone looking at the dash while your under wigglin stuff. Open return I'll need to research the diagram.

 

https://www.ford-trucks.com/forums/8...-460-code.html
Here is a good read for info