Diy 9 inch
Thread Starter
|
Senior User
Joined: May 2007
Posts: 128
Likes: 0
From: Kingston Springs tn
Diy 9 inch
Is there anyone that has built a 9 inch third member without the use of a hydraulic press?
I'm skilled enough to do the job but don't have a press. I was quoted roughly $500 just to assemble a third member!!! I was thinking more like $125.
Anyone have any suggestions?
Stock rebuild btw. Nothing fancy. Just trying to get this old 82 f150 off jack stands and running again.
I'm skilled enough to do the job but don't have a press. I was quoted roughly $500 just to assemble a third member!!! I was thinking more like $125.
Anyone have any suggestions?
Stock rebuild btw. Nothing fancy. Just trying to get this old 82 f150 off jack stands and running again.
Thread
Thread Starter
Forum
Replies
Last Post
Ryan99
Clutch, Transmission, Differential, Axle & Transfer Case
3
Nov 13, 2008 08:17 PM
