help! stall and no start
Thread Starter
|
New User
Joined: Aug 2016
Posts: 2
Likes: 0
help! stall and no start
Hey guys, new to this forum. I have a 2004 f350 with a 03 bullet proofed motor. The truck did not have any power and the turbo wouldn't help until I put a new vgt solenoid in and it ran great for about 3 miles... Stalled doing 65 kinda lacked power while accelerating but got up to speed quick. I pulled over and no start. It is running error code kam on pcm from disconnecting batteries but could this cause the stall and no start? Or should I be looking into icp sensor? Any help would be great thanks
Lead Driver
Joined: May 2014
Posts: 6,545
Likes: 13
From: Virginia Beach VA
What are you getting for an ICP reading? Any live data device, like Torque or Scan Gauge 2?
If not, we are guessing. But since we are, probably an HPOP issue as the 03/04 pumps are horrible, not a matter of if... it's when!
If not, we are guessing. But since we are, probably an HPOP issue as the 03/04 pumps are horrible, not a matter of if... it's when!
Thread
Thread Starter
Forum
Replies
Last Post
