This is a 52 M3: I am repairing the box and there is a "trim piece" missing that I would like to replace the same as the original. It was spot welded on the rear floor support but I have no idea what it looked like. Would anyone have good pictures or diagram of what it looks like? thanks Don T



box corner




upside down box

 

I think this thread includes the information you are looking for: https://www.ford-trucks.com/forums/1...it-attach.html

Thanks for the pictures, it really helps clarify the question.

 

Thank you 38 coupe for the link, lots of info here, however the pics do not seem to relate to my truck for whatever reason, could be a Canadian thing. The factory spot welds are in a row, the pic shows this. ??


new pic

 

you can get that roll from Mack-Hils.

Ford Sub Frames |

This is the company that makes parts that Dennis Carpenter et al sell.

Dan Sokol

 

Thanks Dan for the link. There does not appear to be a part in that catalog that would replace my missing one. For those with these f2,f3 trucks they have to remember that the bed is 8 ft long and approx 54" wide, also fenders do not fit the f1 trucks. So far I have not been able to find anyone who makes these replacement parts. So I am still looking. Thanks again

 

I dont think anyone makes new fenders for the F-2/3.
, you need to find used

Ed
near Philadelphia

 

I am sure nobody makes this part, may I go back to my original question which was "does anybody have a photo or diagram of this valance" I am sure it could be easily made up. Thanks Guys