clutch fork ball bushing
Logistics Pro
Joined: Mar 2005
Posts: 3,771
Likes: 80
From: tujunga, calif
The original ball/nut combo (one piece) would have had a 13/16 hex to turn and the inside would have been 3/8" probably SAE. There woud have been a reg 3/8th nut on the rod to jam the ball/nut after adjusting.
In a pinch and if you have access, get the half ball from a rocker arm, such as on a 240/300 and try it for size against the hole in the fork arm and use two 3/8" nuts
In a pinch and if you have access, get the half ball from a rocker arm, such as on a 240/300 and try it for size against the hole in the fork arm and use two 3/8" nuts
Thread
Thread Starter
Forum
Replies
Last Post
mwk
1994.5 - 1997 7.3L Power Stroke Diesel
8
Feb 12, 2008 04:55 PM
DieselFuelOnly
1999 - 2003 7.3L Power Stroke Diesel
1
Mar 27, 2007 08:33 PM
