Tugger II shift kit Question

Reply Subscribe

Thread Tools

Search this Thread

Dec 1, 2015 | 05:17 PM

hotrodfeguy

Thread Starter

More Turbo

Joined: Mar 2003

Posts: 578

Likes: 1

From: Green Bay Wi

Tugger II shift kit Question

I have all things done but move ***** around and plate orifice. says place 1/4 steel ball on orifice and hit with small hammer to tighten orifice in plate. Am I to assume this is to hold the Orifice from coming out? And to seat the steel ball? Ball stays in with the trans or was it there just to seat the orifice? Sorry if I over thought this but getting late/long on the project. I think you guys know how that can be LOL.

Dec 1, 2015 | 05:41 PM

trackspeeder

More Turbo

Joined: Feb 2004

Posts: 643

Likes: 3

From: North Branford

Its there to seat the orifice.

Dec 1, 2015 | 10:54 PM

hotrodfeguy

Thread Starter

More Turbo

Joined: Mar 2003

Posts: 578

Likes: 1

From: Green Bay Wi

Thank you sir, I guess its fun with check ***** in the morning then LOL. I still have my reservations about moving them around but must be a reason for it.

Dec 4, 2015 | 08:11 AM

mueckster

Lead Driver

Joined: Jun 2003

Posts: 8,298

Likes: 25

From: Damon (South East Texas)

Quote:

Originally Posted by hotrodfeguy

Thank you sir, I guess its fun with check ***** in the morning then LOL. I still have my reservations about moving them around but must be a reason for it.

What is this "moving ***** around" that you speak? They should be placed in there stock locations. The instructions only refer to the different types of valve bodies, and that some do not use check ***** in certain locations by design.

Dec 4, 2015 | 11:16 AM

hotrodfeguy

Thread Starter

More Turbo

Joined: Mar 2003

Posts: 578

Likes: 1

From: Green Bay Wi

Well according to the instructions the mapping showed some in other spots. I did however call into trans go and they said the exact same thing do not move them. So I placed them back where they belong.

I love the shifting on this thing. I do have to say though it did make the shift points a tad latter. Not that thats a bad thing for pulling a load.