Pyro sensor relocatiom
Thread Starter
|
Senior User
Joined: Feb 2006
Posts: 479
Likes: 0
From: Sonoma, CA
Pyro sensor relocatiom
The thermocouple probe for my pyro is in the downpipe. I'd like to relocate it to the drivers side manifold? Any issues with this? I know not to cut the lead wire. There are not special probes meant for post turbo are there? Also how the hell did you all get a drill and bit up in there to drill the manifold. Mine is an Isspro gauge and I think the thread for the probe is 1/4 npt. Needs a big hole to tap and it's a long bit.
Hotshot
Joined: Dec 2012
Posts: 11,278
Likes: 1,658
From: Las Cruces New Mexico
I had my manifold off when I "tapped it"
. I was fixing an exhaust leak and doing my up pipes. But a drill will fit in there just fine. Remember to wear safety glasses, collar shirt, long sleves.
. I was fixing an exhaust leak and doing my up pipes. But a drill will fit in there just fine. Remember to wear safety glasses, collar shirt, long sleves.
Senior User
Joined: Jan 2015
Posts: 124
Likes: 2
Thread
Thread Starter
Forum
Replies
Last Post
DG65
1994.5 - 1997 7.3L Power Stroke Diesel
12
Jul 15, 2008 02:55 PM
