Can someone please help
Thread Starter
|
New User
Joined: Sep 2015
Posts: 2
Likes: 0
Can someone please help
Can someone help? I need the PCM pinout for a 2002 F150 4.6 For the Purge Control Valve Circuit. If possible the wire schematic would be nice also. Getting code PO443 (( hard code )) I have checked battery voltage at valve connector with key on (( 12.2 volts )) valve resistance is at be 35 ohms so I'm thinking I may have a bad wire or a bad PCM . Please correct me if I'm wrong ? Thanks
Senior User
Joined: Oct 2014
Posts: 224
Likes: 1
From: St. Petersburg, Fl
Thread Starter
|
New User
Joined: Sep 2015
Posts: 2
Likes: 0
Check this thread.
https://www.ford-trucks.com/forums/1...g-diagram.html
https://www.ford-trucks.com/forums/1...g-diagram.html
Thread
Thread Starter
Forum
Replies
Last Post
