4x4 not working
Thread Starter
|
New User
Joined: Jul 2015
Posts: 1
Likes: 0
4x4 not working
I was driving down the highway here in town when my 08 F250 diesel started chugging, it stopped as fast as it started. Then about half a mile later I was leaving a stop light and it started doing it again and so I pulled over immediately and when I did I looked to see if my check engine light was on and it wasn't but my 4x4 low light was blinking non stop but the switch was in 2wd. I tried to switch it to 4x4 high with no luck so I tried to switch it to 4x4 low with it in neutral and nothing. I ended up shutting down the truck waited a minute and started it back up and the light was not blinking anymore. It ran and drove just fine but now it won't switch into 4x4 high or low??? Help please!
Thread
Thread Starter
Forum
Replies
Last Post
