HELP Please
Thread Starter
|
Senior User
Joined: Mar 2006
Posts: 342
Likes: 0
From: Rolla, MO
HELP Please
I just installed a wicked wheel, and have the turbo housing back on. I'm trying to re-attach the wastegate but I can't get it back on. I followed videos to do this and I took it off the housing by removing the 2 nuts on the back. Well now I can't pull it out far enough to drop it back into the holes. How can I get this back on? If I take the clip off the other end is it going to still line up after I get the nuts back on? None of these videos showed them putting it back on, I guess I know why now. I need some quick advice on how to do this please. I'm so close to being done but so far....
Posting Guru
Joined: Mar 2014
Posts: 1,468
Likes: 5
From: Salt Lake City, utah
do you have and air compressor if so take a blow gun and hold it an inch or two away from the end of the nipple and apply a little air very very very little amount of air and it should extend out far enough for you to get it on- no more than 5PSI.
Thread Starter
|
Senior User
Joined: Mar 2006
Posts: 342
Likes: 0
From: Rolla, MO
Just tried what you said. It moves a little but it still wont go enough to get it back on. It feels like it's bottomed out. I'm going nuts and it's hotter than Haiti here right now!!!
Thread Starter
|
Senior User
Joined: Mar 2006
Posts: 342
Likes: 0
From: Rolla, MO
Thread
Thread Starter
Forum
Replies
Last Post
90pioneer
1999 - 2003 7.3L Power Stroke Diesel
8
Jul 16, 2014 09:46 PM
