Crankshaft will not turn
Thread Starter
|
Freshman User
Joined: Nov 2011
Posts: 37
Likes: 0
Crankshaft will not turn
Hey Gents,
The rookie is here again. I have a 2003 Ford Expedition witha 4.6. I have been doing a rebuild on it. I had the engine put back together and dropped it in the truck. After trying to bolt the flex plate and torque converter together got to the third nut and the engine will not spin. To get the fourth one. So I thought I screwed up the timing. I have taken it all apart again with. The engine still installed still not able to turn the crank. I am at a loss as what I have done or what to do next. Any help will be appreciated.
Thanks all,
Jim
The rookie is here again. I have a 2003 Ford Expedition witha 4.6. I have been doing a rebuild on it. I had the engine put back together and dropped it in the truck. After trying to bolt the flex plate and torque converter together got to the third nut and the engine will not spin. To get the fourth one. So I thought I screwed up the timing. I have taken it all apart again with. The engine still installed still not able to turn the crank. I am at a loss as what I have done or what to do next. Any help will be appreciated.
Thanks all,
Jim
Thread
Thread Starter
Forum
Replies
Last Post
WillFargo
Explorer, Sport Trac, Mountaineer & Aviator
2
Nov 28, 2011 01:02 PM
robraz
Clutch, Transmission, Differential, Axle & Transfer Case
4
Oct 3, 2004 01:52 PM
