Home made tool
Thread Starter
|
Post Fiend
Joined: Jun 2003
Posts: 8,209
Likes: 12
From: Black Hills of SD
Home made tool
I'm putting this here because it's where more old school guys are who would appreciate it. Mods, move it if you like.
I used to make these 30-40 years ago, before snap on came out with sets. I use broken truck hoist cables. The wire is really strong steel. Cut, bend and sharpen to suite your need. I also usually remove the ****. This one I just made to get some pesky O-rings out of the groove.
I used to make these 30-40 years ago, before snap on came out with sets. I use broken truck hoist cables. The wire is really strong steel. Cut, bend and sharpen to suite your need. I also usually remove the ****. This one I just made to get some pesky O-rings out of the groove.
Laughing Gas
Joined: Apr 2004
Posts: 819
Likes: 2
From: Northern Maine
I have a couple of those in my tool box. Glad to see someone else had the same idea. I also got a hand full of dental picks from my dentist. Apparently when they break the tip off they can't use them anymore and just throw them out.
Thread
Thread Starter
Forum
Replies
Last Post
dieself250
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
1
Feb 28, 2006 05:58 PM
