Floor pan patch panels- how big?
Thread Starter
|
Laughing Gas
Joined: Oct 2013
Posts: 947
Likes: 6
From: Manitoba, Canada
Floor pan patch panels- how big?
The floor rust in my 68 is all in the corner and slightly up on the side as well as the lower corner of the door opening. Will the patch panels you buy cover these areas?
Senior User
Joined: Sep 2009
Posts: 474
Likes: 3
From: Central Wisconsin
The DC panels that I used were plenty big. It ran from the firewall seam, down and across the floor and then curved up maybe 2". From the kick panel across the floor and curved 2" up the center hump. The kick panel edge is a straight flat edge. I had to weld in new kick panels in mine.
Got any pics?
Got any pics?
Logistics Pro
Joined: Nov 2003
Posts: 4,371
Likes: 7
From: PA
Here's a picture during my floor pan replacement. I got mine from LMC they seem alittle bit thin but the fitment wasn't to bad. Now when it comes to the cab mounts they are junk all around. Dennis carpenter has better quality cab mounts but not sure if the floor pans are also thicker as well or not. I haven't seen anyone make kick panel patches yet that I know of. I still need to latch mine as they are rusted about 5-6" above the floor pan. I was thinking of making an access door while I'm at it to clean out in the rocker area from time to time.
Thread
Thread Starter
Forum
Replies
Last Post
59flatbedford
1948 - 1956 F1, F100 & Larger F-Series Trucks
4
Apr 8, 2010 09:01 AM
waynaferd
1967 - 1972 F-100 & Larger F-Series Trucks
5
Feb 12, 2009 06:07 PM
