Intercooler Questions?
Thread Starter
|
Senior User
Joined: Nov 2004
Posts: 240
Likes: 0
From: Appleton, WI
Intercooler Questions?
Hey everybody got few questions on an intercooler installation. The truck is a 1978 f-250 4x4, 6.9, typ4 torque cam, and banks sidewinder. I have a aluminum superduty intercooler. Does it matter what way the air goes through it? As in what side is the inlet or outlet? Also what size do you recommend for the piping to and from the intercooler? Should i just run the same size as the outlets or is there a benefit to use a smaller or larger diameter? Thanks.
Postmaster
Joined: Dec 2004
Posts: 2,941
Likes: 30
From: Maple Valley, WA
The Inlet and Outlet is 3.25"... That's un-necessary....
I have 3" on my setup, and its probably overkill, but works well.
Really depends on the fuel being run and what overall goals are...
For most with a DB2 pump, 2.5" will be fine.
I have 3" on my setup, and its probably overkill, but works well.
Really depends on the fuel being run and what overall goals are...
For most with a DB2 pump, 2.5" will be fine.
Thread
Thread Starter
Forum
Replies
Last Post
