Washer Nozzle Adlustment
Thread Starter
|
Junior User
Joined: Jan 2011
Posts: 50
Likes: 0
Washer Nozzle Adlustment
Does anyone know how to adjust the washer nozzle on a 90 F250? The left side sprays down near the bottom of the windshield and the right side sprays right where it should.
Senior User
Joined: Jan 2014
Posts: 160
Likes: 0
From: Lincoln, NE
I think they just snap in place... there's not really any adjustment. you could try taking a sharp object like a test light and see if there's any crud built up in there that forces the spray down lower.
Postmaster
Joined: Nov 2011
Posts: 3,533
Likes: 17
From: SW Florida
I don't remember ever seeing any adjustment on them.
I'd just take a really small drill bit and clean them out.
If that doesn't help them epoxy the nozzle shut and re-drill a hole at the correct angle... or just get new ones.
I'd just take a really small drill bit and clean them out.
If that doesn't help them epoxy the nozzle shut and re-drill a hole at the correct angle... or just get new ones.
Elder User
Joined: Jun 2013
Posts: 712
Likes: 0
From: Booneville, Missouri
Windshield Washer Nozzle
Take care
Boon
Its Comin Right for us!
Joined: Feb 2005
Posts: 12,158
Likes: 2,638
From: GA
I troubleshot my system this weekend. got lines cleaned out and motor working reliably. cleaned out my nozzle and it works great. one problem, i must have cleaned it out too well. now it sprays fluid over the cab, lol, both streams.
is there anything avail aftermarket for replacement of these? I hate to try filling holes and re-drilling being as i screwed up just cleaning one out. Ive checked auto parts stores rock auto etc.
Maybe i should try cutting a small slit in each hole to make it spray vs. pencil stream?
This would be perfect if i was still a teenager, turn the nozzle around 180* and spray unsuspecting pedestrians
is there anything avail aftermarket for replacement of these? I hate to try filling holes and re-drilling being as i screwed up just cleaning one out. Ive checked auto parts stores rock auto etc.
Maybe i should try cutting a small slit in each hole to make it spray vs. pencil stream?
This would be perfect if i was still a teenager, turn the nozzle around 180* and spray unsuspecting pedestrians
Thread
Thread Starter
Forum
Replies
Last Post
