Doing a suspension swap on a 99 F350 dually, putting a 2007 front and rear-end under it. Ran into an issue with the shock mounts, the 07 are on the front of the axle and I need them on the back side. If I cut them off and weld back it will screw up the mounting of the sway bar that mounts to them. So, would it be best to just add a set to make it work, sorta stumped here...

Thanks

 

why not build a mount to use them on the front of the axle?

 

that would probably be the easiest way to do it.

 

Fuel tank and the exhaust is in the way on the front, just made some for the rear of the axle.