Cold Start issue
Thread Starter
|
Posting Guru
Joined: Dec 2012
Posts: 1,644
Likes: 3
From: SW Ohio
Cold Start issue
So it has been cold here the last week. Truck is not plugged in at work and it won't start like it does when it is plugged in at the house.
Today it took 4 tries before it caught and ran. Temperature was in the mid 20's.
So is this normal? I have no CEL, no codes were present when I scanned it.
Today it took 4 tries before it caught and ran. Temperature was in the mid 20's.
So is this normal? I have no CEL, no codes were present when I scanned it.
Token Redneck
Joined: Jun 2007
Posts: 9,339
Likes: 349
From: Breckenridge, TX
What does the Scangauge say when you're trying to start it? ICP/IPR, FICM, engine voltage, all that jazz.
In the mid 20's, no it's not cold enough to cause a starting problem just because of the cold. You'll know if there's 15W40 or 5W40 based on how it sounds, but it should start with either.
In the mid 20's, no it's not cold enough to cause a starting problem just because of the cold. You'll know if there's 15W40 or 5W40 based on how it sounds, but it should start with either.
Thread
Thread Starter
Forum
Replies
Last Post
