3G Conversion Removing excess wiring
Thread Starter
|
Senior User
Joined: Apr 2012
Posts: 324
Likes: 0
From: Spencer Mountain, NC
3G Conversion Removing excess wiring
I'm doing the 3G conversion on my truck but am unsure what to do about the old wiring that will no longer be used. Don't really want to just tape it up and leave it. Would prefer completely removing all that isn't needed. Can anyone describe which wires I can remove and where to cut them so that I end up with a neat harness?
Fleet Owner
Joined: Dec 2009
Posts: 20,678
Likes: 83
From: NorCal
Describing would take too many words. How about pics!? Go to page 19 of this thread: https://www.ford-trucks.com/forums/9...l#post11242241
BEFORE cutting, identify the wiring while it is installed. Then take up the slack by folding the wire against itself and then wrapping it with tape. Now remove the harness from the vehicle for cutting, soldering, and heatshrinking.
BEFORE cutting, identify the wiring while it is installed. Then take up the slack by folding the wire against itself and then wrapping it with tape. Now remove the harness from the vehicle for cutting, soldering, and heatshrinking.
Thread
Thread Starter
Forum
Replies
Last Post
81F100C
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
3
Jul 20, 2012 06:55 PM
86straightsix
Ford Inline Six, 200, 250, 4.9L / 300
4
Jun 26, 2011 03:30 PM
Bagbyknoter
Ford Inline Six, 200, 250, 4.9L / 300
2
Nov 19, 2010 08:15 PM
