Glowplug codes.
Thread Starter
|
Elder User
Joined: Jan 2011
Posts: 951
Likes: 2
From: Center, Texas
Glowplug codes.
Had some dtc's so ran AutoEnginuity and came up with some glowplug codes. There are some fuel stuff on there too but my fuel level gauge has been acting up time to time. My question is since our glowplugs are pretty solid, should I look be looking at the module itself? I have not done anything other than pull these codes. Thanks.
Hotshot
Joined: Dec 2003
Posts: 15,368
Likes: 121
From: Stuttgart, Ar
You need to ohm the glow plug and glow plug wire separately. You can have either one bad and the GPCM will code it. Unfortunately you have to pull the harness to do it and you can break the plugs where they go through the rocker box because they're fragile. You should obtain readings between 0.5 to 2.0 ohms on all four circuits
Thread
Thread Starter
Forum
Replies
Last Post
