help removing warn hubs
Thread Starter
|
Mountain Pass
Joined: Oct 2010
Posts: 109
Likes: 0
help removing warn hubs
OK I am pretty sure my warn locking hub is shot. I put it in the lock position and I can still turn my u joint by hand. I got the cap off and the otter metal ring out. There was No inner snap ring to take out. So now it should Just come out right? O do I pry it out? Please help.
Cargo Master
Joined: Feb 2011
Posts: 3,450
Likes: 13
From: Forest lake minnesota
Yes if you got the outer snap ring off then it should slide out. If it is stuck you could put the outer lock out part back on without the snap ring and that would give you something to grab on to at least..
Cargo Master
Joined: Feb 2011
Posts: 3,450
Likes: 13
From: Forest lake minnesota
Sounds good let us know how it goes, On a side note I would check your axle shaft needle bearings because in the pic it looks like the stub shaft is crooked and that combined with the fact that your lockout hub is toast would lead me to believe you have issues..
Cargo Master
Joined: Feb 2011
Posts: 3,450
Likes: 13
From: Forest lake minnesota
Typically ball joints wont take out a lockout hub, I would take the wheel hub off and check the needle bearings. You have to take off the 4 bolts on the back side and the whole hub will come off. You might have to tap on it a little to break it lose.
Thread
Thread Starter
Forum
Replies
Last Post
tsevrens
1987 - 1996 F150 & Larger F-Series Trucks
4
May 31, 2017 04:52 PM
