im having a problem deciding on what to do with my new edelbrock performer intake but since I em going with an hei distributor alot bigger tryin to figure out what to do with my heat core line that runs into intake on that side the big huge thing I have will be way to big has like 4 different lines off it an sensors I wont be needed any emissions' stuff
just wondering if anyone else went fr stock 2 brl intake to a 4brl

 

I have a bit of experience with that manifold, but can't understand your post enough to respond. If you write it in English with reasonable capitalization and punctuation I will attempt to answer.

 

I think he's asking about intake heat and emissions equipment. Not rightly sure. It's got plenty of English, though grammar would be great!

 

I'll be more explicit: There are lots of people wanting help, and I have many, MANY things I want to do. So I'll help those who help me by taking their time to state things with reasonable English, punctuation, and grammar. But I will not take my time to try to figure out what those who don't bother to help me help them by typing gibberish are trying to say.

 

sorry guys
just wondering on how to run my heater core line to top of that intake with an hei distributor..
emission's stuff I don't need.
cause that intake only has 2 spots on the front of that intake one for temperature sensor an one other one
just wondering if anyone else ran into this problem?

 

Hey gomer,
You could use a T fitting. Run your temp sensor into the top and the heater hose can come off the side fitting. Just an idea.

Good luck.

 

Good idea. But make sure the end of the sensor is in moving coolant. In other words, don't put it where it won't be seeing the true temp of the coolant, which would happen if you don't have flow through the heater core.