M/C removal help
#1
#2
As I recall without crawling up under my truck, you don't necessarily have to remove the push rod at all from the pedal assembly. Just unbolt your MC and pull it straight backwards away from the chassis crossmember. The push rod will slide out of the rubber boot, and you can install the new master cylinder the same way.....unless of course the pushrod is your problem to begin with. Just clean it up and re-use it. The only problem you'll have is if it's too corroded for adjustment.
Thread
Thread Starter
Forum
Replies
Last Post
vol1966
1967 - 1972 F-100 & Larger F-Series Trucks
2
04-11-2010 06:08 PM
04F150N56F100
1948 - 1956 F1, F100 & Larger F-Series Trucks
10
02-29-2008 07:40 AM
houlis
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
2
08-07-2007 09:23 AM
echo
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
3
08-08-2003 04:06 PM
Chaiyz
1978 - 1996 Big Bronco
1
12-10-2002 06:12 PM