Gear swap help
Thread Starter
|
Fleet Mechanic
Joined: Oct 2007
Posts: 1,998
Likes: 125
Gear swap help
Im working on swapping the gears out of a 77 housing into my 66 housing.
I have pulled the axles out of the 77 rear end. The axles are 28 spline and are tapered, but I think they are the kind that can be resplined.
I have all of the bolts out of the center section, but cannot get the center section seperated from the housing. Im afraid to bang on the center section to much, I dont want to break it.
Any tips on how to get these two pieces seperated.
I was told this was a traclok. What gear oil should I use and how much? 2.25 qts is what the AZ website says.
I have pulled the axles out of the 77 rear end. The axles are 28 spline and are tapered, but I think they are the kind that can be resplined.
I have all of the bolts out of the center section, but cannot get the center section seperated from the housing. Im afraid to bang on the center section to much, I dont want to break it.
Any tips on how to get these two pieces seperated.
I was told this was a traclok. What gear oil should I use and how much? 2.25 qts is what the AZ website says.
Thread
Thread Starter
Forum
Replies
Last Post
ZSK
1948 - 1956 F1, F100 & Larger F-Series Trucks
10
Jun 29, 2015 03:11 PM
ryansmith159
1973 - 1979 F-100 & Larger F-Series Trucks
22
May 25, 2014 06:38 PM
Johns331
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
3
Oct 4, 2000 07:33 PM
