December Meet
#31
#32
#37
Sorry to run out on you guys. Mokkun was so very happy to be home.
When we picked him up there was food siting in his dish at the vet. He
DID NOT want to be taken out of the cage. Once I got him out he grabbed
onto me with his claws till he saw I had his crate open and his pad in it.
He jumped in. On the way home he did a lot of talking. The rest of the clan
was happy to see him. He walked around the house and went upstairs and
used the cat box. Minutes later he was down in the kitchen and sniffing empty
food dishes. So I got him some of the new RX diet stuff and put it down for him.
You would of thought that he had been starved for weeks they way he went at it.
Just happy he is home.
Sean
When we picked him up there was food siting in his dish at the vet. He
DID NOT want to be taken out of the cage. Once I got him out he grabbed
onto me with his claws till he saw I had his crate open and his pad in it.
He jumped in. On the way home he did a lot of talking. The rest of the clan
was happy to see him. He walked around the house and went upstairs and
used the cat box. Minutes later he was down in the kitchen and sniffing empty
food dishes. So I got him some of the new RX diet stuff and put it down for him.
You would of thought that he had been starved for weeks they way he went at it.
Just happy he is home.
Sean
#38
Haha that's good to hear and no problem on leaving us. Me and Josh sat there till around 11 talking while the vehicles warmed up. That heater in the Ranger is amazing. I wish it was that good in the bronco. After you left we has some beer (thanks Josh ) and talked till about 10:30 maybe. Possibly later then let so we weren't in the way of the workers closing up shop.
#39
#40
That's not a bad idea, i think my current one could use replacing anyways. Though it doesn't help that there isn't a place in the bronco where cold air gets in. Especially the gaping hole in the floor for the 4wd lever. It usually gets ok heat and it's enough to defog the windshield but not nearly enough to warm me up. I also don't have dash vents so thats kind of a bummer but i'm sure a new T-stat would get things moving better. I could also flush the coolant again an this time get all the junk out of the block too. Last time i couldn't cause i didn't remove the T-stat.
#41
well dylan, you should get a heater like i've got in the van - an extra 30,000 BTU is a helluvalot - maybe even too much for you. tonight it was about 32* out, and i was plenty warm with the heater on low and the window open an inch - and not even touching the factory "high output" heater - its tiny in comparison
we were talking about torque wrenches as we were standing outside, i guess i posted the coupon for that in the BS thread, i won't bother re-posting it here. all they'll need is to be able to read the barcode number off the coupon i posted there, and you'll get it for 10 bucks
and thank you guys for the pizza!
we were talking about torque wrenches as we were standing outside, i guess i posted the coupon for that in the BS thread, i won't bother re-posting it here. all they'll need is to be able to read the barcode number off the coupon i posted there, and you'll get it for 10 bucks
and thank you guys for the pizza!
#42
#43
Rush him back for what?
I don't think that coupon had a barcode but i may be mistaken. They might have those instore coupons too. Also yeah i think 30k BTU's is a bit much for me. I would try the T-stat and stuff first off before looking into external heating. I don't really know where i would put it either.
I don't think that coupon had a barcode but i may be mistaken. They might have those instore coupons too. Also yeah i think 30k BTU's is a bit much for me. I would try the T-stat and stuff first off before looking into external heating. I don't really know where i would put it either.
#44
Thread
Thread Starter
Forum
Replies
Last Post