Front spindle nut socket size
Thread Starter
|
Molon Labe
Joined: Dec 2006
Posts: 5,272
Likes: 1
From: Alaska
Front spindle nut socket size
Does anyone know what size socket fits the spindle nut on a 2wd.
I'm changing out my wheel bearings tomorrow on my dually, I'll have to buy a socket in the morning.
The darn thing is buried deep in the hub, so no chance using a crescent wrench.
I'm changing out my wheel bearings tomorrow on my dually, I'll have to buy a socket in the morning.
The darn thing is buried deep in the hub, so no chance using a crescent wrench.
Postmaster
Joined: Dec 2010
Posts: 2,951
Likes: 4
From: Gary,Indiana
Frank I don't remember exact size but I used a socket out of a kit I have for doing front wheel drive axles 29mm to 38mm. So I think you could go to Advance, Auto Zone and get a front axle nut socket kit on their loaner tool deal and I know one of them fit.
Post Fiend
Joined: Dec 2009
Posts: 15,505
Likes: 18
From: Livoina,La
Thread Starter
|
Molon Labe
Joined: Dec 2006
Posts: 5,272
Likes: 1
From: Alaska
Thanks Mike,
I'll grab one in the am.
I have to run up to NC this weekend, and then Texas in the next week or two...
almost 4000 miles, so I have get a little maintenance done while I have the chance.
I'll grab one in the am. I have to run up to NC this weekend, and then Texas in the next week or two...
almost 4000 miles, so I have get a little maintenance done while I have the chance.
Thread
Thread Starter
Forum
Replies
Last Post
flamesoldier
1948 - 1956 F1, F100 & Larger F-Series Trucks
13
May 31, 2012 10:18 AM
