Bronco Project
Thread Starter
|
Laughing Gas
Joined: Nov 2000
Posts: 1,072
Likes: 3
From: tulsa
we are finally getting some were on this bronco. We got it through paint finally and will start wet sanding and buffing on Monday. Final assembly will be taking place the next few weeks and hope to have the bronco on the road in the next month if I don't run into many problems.
The aftermarket fenders did not fit good so we cut the back off and made it fit
then we jamed all the parts
sprayed bed liner on the floor and back of the fenders
Then put it together and took it to a paint booth to shoot the out side
final product before buffing
The aftermarket fenders did not fit good so we cut the back off and made it fit
then we jamed all the parts
sprayed bed liner on the floor and back of the fenders
Then put it together and took it to a paint booth to shoot the out side
final product before buffing
Thread
Thread Starter
Forum
Replies
Last Post
