Hey, if any of you are looking for a Dakota cross member for your front suspension, check out what Industrial Chassis is doing now. Here is a link to his Facebook page.

Wall Photos | Facebook

Steve, is ready to start production on new cross member kits for Ford trucks. This is a new design, improved from the previous design to ease installation and production. Check them out.

Phil

 

looks like a very nice set up! Steve does great work!!!

 

Hey Phil, and I think Gil there goes by Charger? I seem to remember the hood sectioning from Allmetalshaping.

Yeah, kits are back into production. Working my butt off to get all the year models done. I picked up a 54 F100 to build for myself, and to do the kits from. I should do a build thread here when I get going on it.

Steve

 

Looks like it should work out pretty good. How low can you get the trurck to sit? Any pictures of a finished install? How much is the sub frame?

 

This is a picture of a 62 with my old kit installed with a stock spindle.



The earlier trucks sit a bit lower, this one has 2" dropped spindles

 

Can you keep it close to stock height?

 

Stock spindles and the V8 springs gets you close,\.

 

Steve,
A build thread would be very much appreciated I think. I have been following your pics on facebook. Thanks

 

- Yep, i`m charger on many other sites!
- believe i seen your kit prices at $750 bux?? thats a bargain!
-can`t wait to see you `54 build!