push bar question
Thread Starter
|
Junior User
Joined: Feb 2010
Posts: 56
Likes: 0
push bar question
I got an 89 full size and just got a heavy duty push bar that was on an explorer..any ideas on how to make this work on my bronco?? Push bar is 30 1/2 inches wide and my frame rails are like 34-35... any ideas?? I can fab something but trying to figure out the right way to do it..
Moderator & parts slinger
Joined: Feb 2007
Posts: 50,247
Likes: 5,815
From: S/W Missouri, Polk county
Either make the bar wider if it is round and not chrome add some pipe right in the middle to fill the dirrerence.
Or build some brackets to widen or stepout the mounts?
Or build some brackets to widen or stepout the mounts?
Moderator & parts slinger
Joined: Feb 2007
Posts: 50,247
Likes: 5,815
From: S/W Missouri, Polk county
Factory one is bolted to the bumper/frame using the existing bumper mount bolts and holes.
But this is for a 73-79 application, I think I have seen 80's and up the same way??
But this is for a 73-79 application, I think I have seen 80's and up the same way??
Thread
Thread Starter
Forum
Replies
Last Post
kulprit
1987 - 1996 F150 & Larger F-Series Trucks
6
Apr 3, 2007 12:19 PM
