ignition switch question
Thread Starter
|
Junior User
Joined: Mar 2011
Posts: 63
Likes: 0
ignition switch question
Ok so ive had plenty of electrical problems recently. Ive also had problems with my key cylinder. so i figured id go ahead and replace that. when i was pulling that out, following the directions of my chiltons manual, the connector at the end of a black wire, desinigerated. it will still put power to the accesories when i turn the key to the run position but wont start. what is that black wire? can i get a replacement fitting or should i attempt to put it back together? its the fitting that slides down in with the cylinder
Thread
Thread Starter
Forum
Replies
Last Post
BeerKnurd
1961 - 1966 F-100 & Larger F-Series Trucks
4
Sep 27, 2011 05:08 PM
