Crown Vic hardware
Thread Starter
|
Junior User
Joined: May 2003
Posts: 59
Likes: 0
From: Kettering, Ohio
Crown Vic hardware
My boy found a 08 CV front IRS for his 68 F100 cheap, but we have to pull it ourselves..
I'm taking a hoist, and a box of tools, but it would be nice not to take everything....
So, that said, does anyone know the wrench and socket sizes needed to knock this bugger out? Thanks!
Bob Sr.
I'm taking a hoist, and a box of tools, but it would be nice not to take everything....
So, that said, does anyone know the wrench and socket sizes needed to knock this bugger out? Thanks!
Bob Sr.
Senior User
Joined: Aug 2005
Posts: 306
Likes: 0
From: Berthoud, Colorado
Not to sure the exact size but there are onle 4 long bolts that hole the x member in and 3 on the rear of each lower control arm. If the motor is out it should take about 30 minutes at most to get it out. It drops out the bottom.
Posting Guru
Joined: May 2010
Posts: 1,867
Likes: 3
From: Alton, MO
You want to keep the main mounting bolts, complete brake hoses, at minimum the lower portion of the PS lines, as much of the steering shaft as possible & the spacers that are in the CV frame. The spacers are welded in only on the top rail. A slice with the flaming wrench around it and out it comes.
Thread
Thread Starter
Forum
Replies
Last Post
80fordf150
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
4
Sep 21, 2010 01:54 PM
Myfreeford
1973 - 1979 F-100 & Larger F-Series Trucks
11
Oct 13, 2008 01:35 AM
