ebpv..
Thread Starter
|
Junior User
Joined: Sep 2011
Posts: 79
Likes: 0
ebpv..
I know this ebpv crap gets old but I've searched and can't seem to find the answer...so a few days ago its been in the 20s and 30s so I'm hearing the ebpv more and more as expected..well i figure time for the brake mod as it was getting annoying... so I got get a trusty ol 2speed axle switch do all the wiring checked for which side of the ebpv plug received power cut the opposite side and wired it all in leaving the engine harness out of the equation..have my buddy get in flip the switch and voila nothing happens...wtf... pull the plug apart check for power as the switch is cycled and it works ..ok what the heck is the deal with tht..what part puked and where can i get it as id actually like to use it for a jake..
Postmaster
Joined: Sep 2007
Posts: 4,195
Likes: 6
From: Medford Oregon
To troubleshoot need more information how you wired the switch. PCM supplies power to EBPV (12 volts @ 20 HZ. duty cycled) but only when needed.
In your configuration is the switch supping power, 12V .. or a ground?
In your configuration is the switch supping power, 12V .. or a ground?
Thread Starter
|
Junior User
Joined: Sep 2011
Posts: 79
Likes: 0
My switch has three wires..one to power one to ground and the other for signal...I have one wire hooked to power and the other 2 running to the ebpv oneas power one as ground...I hooked it bac up stock and even the truck wiring dosent make it work
Thread
Thread Starter
Forum
Replies
Last Post
79f-250custom
1994.5 - 1997 7.3L Power Stroke Diesel
3
Nov 16, 2007 02:07 PM
