not going into gear
Thread Starter
|
Junior User
Joined: Oct 2010
Posts: 58
Likes: 0
From: Pacifica, CA
not going into gear
FYI: My 52 F1 has a Chevy 327 and a Chevy 400 auto transmission.
I just took my truck out and I noticed it took a couple of seconds to pop into drive. As I was driving I started to hear this high pitched whining sound. I headed home and when I went to back up it wouldn'd go into reverse or drive. I looked at the linkage didn't see anything loose. Then I moved the linkage and it clicked into place then I was able to go into reverse.
Any idea of what this is?
Thanks.
I just took my truck out and I noticed it took a couple of seconds to pop into drive. As I was driving I started to hear this high pitched whining sound. I headed home and when I went to back up it wouldn'd go into reverse or drive. I looked at the linkage didn't see anything loose. Then I moved the linkage and it clicked into place then I was able to go into reverse.
Any idea of what this is?
Thanks.
Post Fiend
Joined: Jun 2001
Posts: 7,493
Likes: 7
From: Erie, pa
A Chevy problem, that should be discussed on a Chevy site - Not dissin you but I know what would happen if I went to the Chevy Barn and asked a question about my Ford engine and tranny thats in my 51 3100
Thread
Thread Starter
Forum
Replies
Last Post
soundwave
1983 - 2012 Ranger & B-Series
7
Jun 27, 2006 07:43 PM
steve83
Clutch, Transmission, Differential, Axle & Transfer Case
9
Jan 6, 2003 06:50 PM
