Victor intake finally on
#1
Victor intake finally on
It took awhile, but it is on. I purchased it from Keith Craft, so he could do his magic on the ports to match the heads he ported. If anyone needs a excellent roller rocker setup, see the below. A local shop makes them here in Redding. They are bullet proof.
Falcon :: P1000175.jpg picture by Maxtor427 - Photobucket
Falcon :: P1000175.jpg picture by Maxtor427 - Photobucket
Falcon :: P1000175.jpg picture by Maxtor427 - Photobucket
Falcon :: P1000175.jpg picture by Maxtor427 - Photobucket
#3
Thanks Glen;
It is just to hot here in Northern California, "for me" to have any fun at our drag strip. The track is open about every other week end, but 100 degree weather is for the young guys. Maybe in September or October. I am heading to Thunder Hill "Willows road course" in September and test out our vette. With the new supercharger, the vette puts out the same horsepower as our Ford FE does "before using the nitrous", 606 hp. per the dyno.
To bad the FE would not fit in the vette.
It is just to hot here in Northern California, "for me" to have any fun at our drag strip. The track is open about every other week end, but 100 degree weather is for the young guys. Maybe in September or October. I am heading to Thunder Hill "Willows road course" in September and test out our vette. With the new supercharger, the vette puts out the same horsepower as our Ford FE does "before using the nitrous", 606 hp. per the dyno.
To bad the FE would not fit in the vette.
#4
Thread
Thread Starter
Forum
Replies
Last Post
maxtor
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
5
06-02-2011 06:45 AM
fordeverpower
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
2
03-12-2007 11:07 AM
fordeverpower
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
10
09-11-2005 02:14 PM
RapidRuss
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
1
05-30-2004 11:51 PM
RapidRuss
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
3
05-29-2004 06:04 AM