Doing a frame off build on a 93 F350 with NA 7.3L. Truck has 150K on it. Still on the OEM clutch which still has some meat on the disc. Want to change it since the motor and trans is out. Any recommendations for the clutch? Can the flywheel be turned? Dont see scoring, but want to turn it or replace it.
Thanks

 

flywheel should be good to mill it. i'd look into a valair clutch for that truck, i have a 500 horse single disc in mine (ya wont need somethin that big) and i paid 345 for it from a sponsor. i imagine somethin around 300 horse for yours would be in the 2-300 range. im right at 500 wheel, and ive had the clutch for over 60k. its been down the dragstrip a few times also. great clutches for the money.

 

If stock, your truck will have a dual mass flywheel. Might want to consider a single mass conversion.
Maybe ask on the Pre-Power Stroke page in the Diesel section for advice.