Hey guys, new to forum and have some questions. About 2 weeks ago while driving home, truck had a hard miss one time on interstate and check engine light came on, continued to run fine the last 2 miles home and once I pulled in driveway, truck cut out. Scanned and got P-0340 (cps) so I replace the next day with a sensor from autozone. Truck started and ran fine for about 10 miles then cut out again. Ok, bad sensor, replaced with another from a different parts store. Truck ran fine for 3 days, then cut out. At this point, the truck would restart and run good til the next day. Everytime the truck cut off, I would get the CPS failure. I replaced with a CPS from Ford. Now truck runs until I get to normal operating temp and cuts out. Will not restart until it completely cools down. Will cold start and run until it reaches operating temp. then cut out. Scanned on a Snap ON scanner and all pressures, temp, etc are good but once engine oil temp reaches 149, truck will cut off. At a complete loss here and hoping someone has had some experience with a simular issue. Last time it cut out, I got a 1283 code and once before, I got a p-0603 but was told that was because of the tuner.

Thanks in advance

202 7.3 F250 132k, Super chip, Banks exhaust, intercooler