dana 80 spline count
Thread Starter
|
Tuned
Joined: Apr 2006
Posts: 410
Likes: 1
From: West Virginia
dana 80 spline count
I just recently got a 06 F350 cab and chassis truck. It has a 13,000lb GVW.
I'm guessing it has the Dana 80 in it. It is an open diff and I was thinking about a limited slip unit.
I see listed for 98 and up a 35 and a 37 spline. Is there any way to tell what I have, besides pulling the axles and counting the splines?
Thanks,
Buck
I'm guessing it has the Dana 80 in it. It is an open diff and I was thinking about a limited slip unit.
I see listed for 98 and up a 35 and a 37 spline. Is there any way to tell what I have, besides pulling the axles and counting the splines?
Thanks,
Buck
Token Redneck
Joined: Jun 2007
Posts: 9,335
Likes: 344
From: Breckenridge, TX
Should be 1.58" 37 spline shafts. I guess there's no way to be 100% sure about anything without looking at it though, but every diff I've seen sold for DRW 350s in the 05-07 lineup lists 37 splines. I remember something vaguely about 35 spline D80s being a pre-88 or pre-96 deal or pre-03, but that's a shot out of left field.
Might be on the axle tag on the diff cover, if there's a 35 or a 37 there's a pretty good change it's not by chance.
Might be on the axle tag on the diff cover, if there's a 35 or a 37 there's a pretty good change it's not by chance.
Thread Starter
|
Tuned
Joined: Apr 2006
Posts: 410
Likes: 1
From: West Virginia
Thanks for the response.
I wanted to check the breaks and try and get the E-brake working right. Guess while I'm back there I'll count the splines to make 100% sure. Don't know when that will be though.
Thanks again.
I wanted to check the breaks and try and get the E-brake working right. Guess while I'm back there I'll count the splines to make 100% sure. Don't know when that will be though.
Thanks again.
Thread
Thread Starter
Forum
Replies
Last Post
Andy_Bracy
Clutch, Transmission, Differential, Axle & Transfer Case
4
Aug 18, 2005 11:20 PM
