2004 expo P3001 Code bad jet programmer?
Thread Starter
|
New User
Joined: Feb 2011
Posts: 11
Likes: 0
2004 expo P3001 Code bad jet programmer?
Well im in a bit of distress here and im hoping that some one might be able to help me out. I have a 2001 f350 v10 and i had purchased a jet power programmer. I have been saving up to replace it with a 5 star unit from mike, so to help i was going to sell my jet one to my friend that has a 2004 expedition with a 4.6Liter. We programmed his truck with no problems to the baseline 87 octane program and 2 days later he was getting a p3001 cylinder #1 misfire code. We immediatley detune it back to stock. He took it out again and it happened again. I replaced the #1 COP and checked the plug, plug was good. I know they go out once in a while. Well today he called and it did it again. Im a little worried that this jet unit (and yes according to their site is compatible) screwed up my buddies truck. and it only happens when the revs are up, say climbing a decent hill. I would appreciate any input. Thanks <!-- / message -->
<!-- controls -->
Thread
Thread Starter
Forum
Replies
Last Post
JL-78
Ford Inline Six, 200, 250, 4.9L / 300
7
Jun 29, 2015 08:58 AM
buckin69bronco
335 Series- 5.8/351M, 6.6/400, 351 Cleveland
13
Jun 23, 2015 01:37 PM
rangermike
2004 - 2008 F150
5
Nov 26, 2012 07:54 PM
