SRWD Hubs
Thread Starter
|
Posting Guru
Joined: Nov 2007
Posts: 2,014
Likes: 1
From: Long Island, NY
SRWD Hubs
I got my hubs today and I am looking for some info on how to get them on. A digram would be nice. And if I have to replace the bearings how do you get the races out?
Thanks
Thanks
Last edited by tjc transport; Mar 26, 2011 at 05:02 AM. Reason: the usual
FTE Chapter Leader
Joined: May 2006
Posts: 11,273
Likes: 99
From: North Dakota
They go on exactly the way the old ones come off.
As for the races, a bfh and a brass drift punch works nice.
I only say brass, because its a softer metal so if you don't know what your doing, you don't mar your races.
I usually use a piece of round stock long enough so I'm standing and the hub/rotor is on the Floor. "Hold" the hub with my feet and beat the races out(working around them, not just in one spot) with the right hammer, should only take about 4 good hits to get each one out
As for the races, a bfh and a brass drift punch works nice.
I only say brass, because its a softer metal so if you don't know what your doing, you don't mar your races.
I usually use a piece of round stock long enough so I'm standing and the hub/rotor is on the Floor. "Hold" the hub with my feet and beat the races out(working around them, not just in one spot) with the right hammer, should only take about 4 good hits to get each one out
Thread
Thread Starter
Forum
Replies
Last Post
FordMan57
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
10
Jan 4, 2020 10:51 PM
