I need a piece of sheet gasket material (<6" ID ->6.5" OD) for the top of my evaporator that has a piece of plexiglass on it to view the process. I checked with McMaster-Carr and they have a viton gasket (9473K75) that will work. Do I need to go to that expense ($17.38) for viton or will the neoprene or silicone which is much less expensive work as well. It is subject to methanol/BD at that point. Fabman, what do you use for your "condensor" ? Thanks. Tom
93 F-250 7.3 Banks turbo, 3.5" exhaust 4" ram air K&N filter E40D 4.10. Pyro, boost, & tranny temp gauges. Tru Cool 28,000 GVW trans cooler. 100% BIO
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company.