351M cranks, all drilled for manual tranny?
#1
351M cranks, all drilled for manual tranny?
Hey guys, it has been a long time since I have had much of chance to get online to see the forums.....I did a search, but I could not get specific enough to find an answer.....
I have a 351 M out of a 78 that has a four speed. ( I want to use this four speed)
I Bought another 351M (don't know what it had for a tranny), and I would really like to use the four speed on this new motor.....as I have all of the parts, and the new truck is already set up for a manual transmission.
My question is, are all 351M cranks set up for a manual transmission, or is there anything else I can do to make it work, without pulling the engine apart, and having the crank drilled?
Also can you please tell me what I should be looking for specifically on the crank,in the new to me engine, to know if I can use the four speed with it.....
Thanks all for your help.
I have a 351 M out of a 78 that has a four speed. ( I want to use this four speed)
I Bought another 351M (don't know what it had for a tranny), and I would really like to use the four speed on this new motor.....as I have all of the parts, and the new truck is already set up for a manual transmission.
My question is, are all 351M cranks set up for a manual transmission, or is there anything else I can do to make it work, without pulling the engine apart, and having the crank drilled?
Also can you please tell me what I should be looking for specifically on the crank,in the new to me engine, to know if I can use the four speed with it.....
Thanks all for your help.
#2
Thread
Thread Starter
Forum
Replies
Last Post
Gear Up
Clutch, Transmission, Differential, Axle & Transfer Case
4
04-20-2003 10:49 PM
Mauserbob
Performance & General Engine Building
4
05-05-2002 09:41 PM