My apologies for making this one of my first posts but I'm stumped.

I have a 2006 E250 and the remote entries have stopped working. The first thing I did was replaced the batteries in each of the remotes. Then I did the ignition key 8 times trick to re-marry the remotes. Still no worky, so I replaced the fuse. The manual says that that circuit runs both the power door locks and the overdrive. The overdrive works fine so I believe that I have verified the circuit is fine.

Anyone have any ideas of where I should look next?

 

I would have to think that it's a receiver module that may be kaput. I believe I've read that it's located slightly rear of the B Pillar, left side.

 

Thanks Jimbomitch.