1958 Ford 9 Pumkin Removal
#1
1958 Ford 9 Pumkin Removal
I'm working on replacing my 3.70 with a 2.75 pumpkin, I have the axles out and the bolts taken off the 3rd member. The housing is loose, meaning I can move up/down & side/side, but I cannot get that bad boy out of there. Feels like something is holding it. It will pry up far enough that the studs are out of the holes either top or bottom, but will not come out. any ideas?
#2
Thread
Thread Starter
Forum
Replies
Last Post
louis1234
Clutch, Transmission, Differential, Axle & Transfer Case
8
11-20-2007 09:55 AM
jjenkins816
Clutch, Transmission, Differential, Axle & Transfer Case
5
01-30-2005 03:55 AM
DRK
Clutch, Transmission, Differential, Axle & Transfer Case
5
06-11-2003 09:33 PM