Im going to change my IPR tomorrow, what do I need to know?

I know I need a 3/4 inch wrench and I think a 1 1/8" Deepwell Socket.

How much Oil shall I be letting out when I crack it open?

Lube on anything?

Sealant on anything?

Special cleaning instructions for hole in hpop?

 

Here's some info that should help

https://www.ford-trucks.com/forums/1...-write-up.html

 

It's pretty simple. Not as much oil as I thought it would be. Lube up the o-ring of the new IPR before installing it. Don't over tighten the tin nut or it will strip out. Check the wiring at the pigtail and make sure the insulation isn't brittle or chaffed.

It's pretty simple.

 

Done, Didn't start still but IPR was not a hard install.

Napa 1 1/8 Deepwell
Stubby 1/2 Drive Pivoting ratchet
Stubby 3/4 Wrench

Only Lost about a mouthful of Oil.
15 Min total time


Thank You all for the assist.