borrowed a scan gauge for the day to check my icp numbers on start up

termy modded 17* hpop

41 degrees outside

thoughts?

click picture to watch video

 

sorry for the crappy quality it was taken with my blackberry

 

You had the camera to close bro.

I don't think that is reading right though. hahaha.

 

Typical idle should see about 650 psi, but tuners do things their own way so maybe that's just how DPT has their's set.

Are you having issues or concerns?

 

i had an o ring leak on the pump ( which ive fixed) had a long crank issue... which is now gone.

i did run the truck hard the other day on my 140 tune and thew a p1211 code

btw the jim... i drove it around for a few and watched the numbers... at a red light it was going between 6-790

 

We had a thread on this a while back Christian.

Tim was asking if others had variations in their ICP numbers from their scan gauge.

They tend to fluctuate a lot.

I do believe there is a firmware update for these gauges. You should check to see which revision the gauge has and compare it to the site.