I have a 1995 f-150 that has been sitting for the last 5 years. The 4.9l in it is tired and in need of a rebuild. I have a 1997 5.8l complete from water pump to flywheel.

The truck is a single cab 2wd short bed, with the mazda manuel transmission. I have the wire harness and the cpu for the 5.8. I also have a 5.8 radaitor.

I know I am going to need windsor motor mounts and the frame perches, any advice or problems I may run into?

Really looking forward to getting the old truck going again.

Here is a pic of my engine