Hello to all!
Just bought my new 2017 f250 and wanting to lift it. I love it! I am thinking 6" with 22x12 and using a 37x 13.5 tires. The question is, what is the best way to lift this truck. Has anybody in this forum lift their 6.2 before? Needing some assistance. I've been researching for the longest time. I was going with Procomp however I do not see anything that will fit. Thanks for your help.

 

That’s exactly what i have. I’m adding air bags to the rear also. I need it level -44 offset
Rides high in the front maybe 1”.

 

I have the same truck. Went with a 6” Full Throttle Suspension Lift with 22x12 -44 MotoMetal, 37x13.5/22 Cooper STT PRO. The websites don’t seem to have the lifts listed as fitting the ‘17 but just call whomever from wherever Lift manufactures you want and they can pair you with the correct lift kit.
This is my favorite photo even though the truck isn’t clear, but I just Love the sun rays down on it.

 

Welcome from the central coast of California


If it were me I would put a leveling kit on the front with air bags on the back. I am not sure what you are going to use your truck for, if its to hi not for much other than driving. My opinion these trucks are high enough coming off the lot.


Good luck either way you go.

 

Im in the same boat might go with a BDS 4" lift and 35s. Those trucks are beasts wit the 37s!

 

Took a little road trip today. Averaged about 10.5 mpg on the dash! Oh yeah pulling nothing!! Lol

 

I just posted a whole Lewis Built kit in the market place, new never used.

 

What type of fender measurements you getting with this kit?
Does it sit level, and did you do any trimming for the wheels?
Thanks.