How to use Existing utility Switches
Thread Starter
|
1st Gear
Joined: Apr 2025
Posts: 1
Likes: 0
How to use Existing utility Switches
Hello, New to site. I need help with using my existing 4 utility switches in my 2015 E-350 Super Duty
Cutaway Van. I have open up the dash to find an existing multi wiring harness the just plugs in behind the
coin tray in the dash. I think there is an aftermarket plug in harness that I would using this loom to plug into.
Also I have found the pass through wires in the engine compartment, but can't find where they are inside the cab.
Need help, Thx
Cutaway Van. I have open up the dash to find an existing multi wiring harness the just plugs in behind the
coin tray in the dash. I think there is an aftermarket plug in harness that I would using this loom to plug into.
Also I have found the pass through wires in the engine compartment, but can't find where they are inside the cab.
Need help, Thx
Moderator
Joined: Jan 2001
Posts: 56,984
Likes: 2,738
From: Virginia
Are your switches factory installed? If they are, and you found the blunt cut wires, you should be good to go. Here is some more info on it.
https://www.sportsmobileforum.com/th...itches.762337/
https://www.sportsmobileforum.com/th...itches.762337/
Thread
Thread Starter
Forum
Replies
Last Post
FixOrRepairDailyF350
1987 - 1996 F150 & Larger F-Series Trucks
3
Feb 20, 2016 11:52 AM
Island Time
1968-Present E-Series Van/Cutaway/Chassis
2
Oct 23, 2014 12:41 PM
