Code Reader
Moderator
Joined: Jan 2004
Posts: 13,851
Likes: 111
From: SW Va
What do the instructions say its checking when it asks that you do the maneuver????
Maybe to check the power steering pressure switch & or maybe the IAC ability to control idle speed when the power steering pump loads the engine. What message, or code does it give you if you ignore the instructions????
Maybe to check the power steering pressure switch & or maybe the IAC ability to control idle speed when the power steering pump loads the engine. What message, or code does it give you if you ignore the instructions????
Thread Starter
|
Laughing Gas
Joined: Apr 2004
Posts: 819
Likes: 2
From: Northern Maine
It instructs me to start the engine and then to turn the wheel 1/2 turn to the right. I don't know what code it would give because I didn't ignore it. My truck didn't have a CEL, I was just playing with my code reader. I will try it again sometime and try it w/o turning the wheel and see what it does. I'm just confused as to what turning the wheel does to anything.
Thread
Thread Starter
Forum
Replies
Last Post
