t19 pto location
Thread Starter
|
Fleet Mechanic
Joined: Apr 2007
Posts: 1,429
Likes: 4
From: patricia ab canada
t19 pto location
hey guy's just got a smoking deal on a pto winch for big red.6 ton tulsa winch and pto with drive shafts.what i need to know is what side of the trans should i put the pto on.both sides of the trans has a pto cover and i'm wondering whats the difference.the passenger side will give me the most clearance. does one side come off the input shaft and give me one speed,and the other side attach to the output shaft and allow me to put the trans in gear and be able to winch with different speeds by choosing different gears. or is there two different locations for choice of mounting locations
i was hoping there would be one on my transfercase for the option of being able to change my line speed with gears.but i'm not that lucky.lol
i was hoping there would be one on my transfercase for the option of being able to change my line speed with gears.but i'm not that lucky.lol
Hotshot
Joined: Feb 2004
Posts: 11,697
Likes: 3
From: Marengo, Iowa
Typical mounting goes on the right side, but the T19 gives the option for both.Clearance of course is one issue, and it depends what you are intending to run with it. If you are going to have actual shafts from it, then you have to make sure you have the clearance to run it. As far as what drives it, it is the same shaft.
Thread Starter
|
Fleet Mechanic
Joined: Apr 2007
Posts: 1,429
Likes: 4
From: patricia ab canada
thanks, was kind of hoping i could use ether side.the passenger side has a lot more room for the pto shaft,and the winch is reverse able so ether side will work.i'll post pics when i get her done .thanks again
Thread
Thread Starter
Forum
Replies
Last Post
