speed density questions
Thread Starter
|
New User
Joined: Jan 2003
Posts: 2
Likes: 0
speed density questions
Hey everybody, I have just bought an 89 F-150 with a spun maing bearing, I am going to repbuilit .30" over, and was wondering if I could run some slightily ported E7TE's, a Lunati Truck Avenger Cam with .210 @.50" intake and exhaust durantion with a .469 intake and exhaust lift. 1l6 roller rockers with long tube headers, and flowmaster exhaust.
I was wondering if I could still run speed density with this setup.
As far as my truck it is a four wheel drive, it already had 3.55 geard and detroit lockers, I gave $500 cause of the motor, did I get a good deal.
Last I am also new to this board and would like to commend you guys for the excelent andvise.
Brandon Behrens
I was wondering if I could still run speed density with this setup.
As far as my truck it is a four wheel drive, it already had 3.55 geard and detroit lockers, I gave $500 cause of the motor, did I get a good deal.
Last I am also new to this board and would like to commend you guys for the excelent andvise.
Brandon Behrens
Senior User
Joined: Sep 2002
Posts: 434
Likes: 2
From: Oregon: Land of the Majes
speed density questions
I might try to get an adjustable fuel pressure regulator with this setup for some extra fuel, and keep an eye out for a loss in engine vaccuum, that is when the computer starts acting up.....
